...
Note - if you need to use the cross section data in calculations further down the stream you should not interpolate.
Line
Missing Data
Specifies the coordinates of a transect line along which the cross-section is calculated. Enter coordinates (lat/long) of a line separated by a "/" (easternmost lat and long, westernmost lat and long); alternatively, use the coordinate assist button (see "Geography help tool" in "Editor Window Help Tools" on page XXX).
Note that it is possible to define a line through either pole by describing the line’s coordinates as follows. First, when specifying the latitudes of the two points, imagine that the latitude values go above 90 when you cross the North Pole and below -90 when you cross the South Pole. Next, if you wish a straight line, ensure that the two longitude values are the same as each other. An example demonstrates this. Say you wanted to defined a straight-line cross-section from 60S/25E to 60S/155W. This would be specified as -60/25/-120/25. The fact that one of the latitude values is below -90 indicates to Metview that a cross-section going through the South Pole is desired. Once this has been established, the fact that the two longitude values are identical tells Metview to use a straight line through the pole. If this is the intent, then only one unique longitude value is required, as the other one can be deduced. Giving Metview two different longitude values will cause a cross-section consisting of two curves to be produced.
Wind Parallel
Setting this option to On will produce a cross section plot of the projection of the wind onto the cross section plane (going from a 3D wind field to a 2D wind field projection). This is plotted using wind arrows. Valid values are On/OffIf set to Ignore, missing data is not included in the output file; this is the default behaviour. If set to Include, missing data will be output to the geopoints file, its value being set to that specified by Missing Data Value. Note that when the output format is one of the two geopoints vector formats, the observation is considered missing if one or both of the parameters are missing.