...
Note that it is possible to define a line through either pole by describing the line’s coordinates as follows. First, when specifying the latitudes of the two points, imagine that the latitude values go above 90 when you cross the North Pole and below -90 when you cross the South Pole. Next, if you wish a straight line, ensure that the two longitude values are the same as each other. An example demonstrates this. Say you wanted to defined a straight-line cross-section from 60S/25E to 60S/155W. This would be specified as -60/25/-120/25. The fact that one of the latitude values is below -90 indicates to Metview that a cross-section going through the South Pole is desired. Once this has been established, the fact that the two longitude values are identical tells Metview to use a straight line through the pole. If this is the intent, then only one unique longitude value is required, as the other one can be deduced. Giving Metview two different longitude values will cause a cross-section consisting of two curves to be produced.
Wind Parallel
Setting this option to On will produce a cross section plot of the projection of the wind onto the cross section plane (going from a 3D wind field to a 2D wind field projection). This is plotted using wind arrows. Valid values are On/Off.
Wind Perpendicular
Setting this option to On will produce a cross section plot showing the projection of the horizontal wind components onto the direction perpendicular to the cross section plane. The result is a one-dimensional quantity and is plotted with contour lines. Also produced is another cross section plot of the W component of the wind. Valid values are On/Off.
Wind Intensity
Setting this option to On will produce a cross section plot of the scalar wind intensity, plotted with contour lines. If one of the previous two parameters is On, then the intensity is that of the specified projection. Also produced is another cross section plot of the W component of the wind. Valid values are On/Off.
Lnsp Param
Specifies the parameter number of the Lnsp data, if you are using non-ECMWF data - ECMWF uses specific parameter numbers different from the WMO ones. Enter whichever parameter number is appropriate for your data.
U Wind Param
Specifies the parameter number of the U wind component data, if you are using non-ECMWF data - ECMWF uses specific parameter numbers different from the WMO ones. Enter whichever parameter number is appropriate for your data.
V Wind Param
Specifies the parameter number of the V wind component data, if you are using non-ECMWF data - ECMWF uses specific parameter numbers different from the WMO ones. Enter whichever parameter number is appropriate for your data.
W Wind Param
Specifies the parameter number of the W wind component data, if you are using non-ECMWF data - ECMWF uses specific parameter numbers different from the WMO ones. Enter whichever parameter number is appropriate for your data.