...
Specifies the coordinates of a transect line along which the cross-section is calculated. Enter coordinates (lat/long) of a line separated by a "/" (easternmost lat and long, westernmost lat and long); alternatively, use the coordinate assist button (see "Geography help tool" in "Editor Window Help Tools" on page XXX).
Note that it is possible to define a line through either pole by describing the line’s coordinates as follows. First, when specifying the latitudes of the two points, imagine that the latitude values go above 90 when you cross the North Pole and below -90 when you cross the South Pole. Next, if you wish a straight line, ensure that the two longitude values are the same as each other. An example demonstrates this. Say you wanted to defined a straight-line cross-section from 60S/25E to 60S/155W. This would be specified as -60/25/-120/25. The fact that one of the latitude values is below -90 indicates to Metview that a cross-section going through the South Pole is desired. Once this has been established, the fact that the two longitude values are identical tells Metview to use a straight line through the pole. If this is the intent, then only one unique longitude value is required, as the other one can be deduced. Giving Metview two different longitude values will cause a cross-section consisting of two curves to be produced.
...