...
Full debugging ('nansC') - this configuration is intended for debugging only. As well as setting the lowest optimization, -O0, it also enables array bound checking and initialisation of variables with special values that will trigger 'not-a-number' exceptions useful for trapping variables used before initialized. This will cause the model to run very slowly and is normally only used for short runs for tracing bugs.
Compilation
...
files and variables
The FCM software uses configuration files identified by the suffix '.cfg'. They can be found in the directory oifs/make/fcmcfg. The master configuration file for OpenIFS is in fcmcfg/oifs.cfg. It sets general configuration options for FCM, lets FCM know where the source code is and reads a single architecture and compiler specific configuration file.
...