...
This page describes basic installation of the SCM and presents some example test cases.
Installing OpenIFS and the SCM
To install the SCM at OpenIFS 48r1 (and beyond) it is first necessary to download and extract the tarball containing the model source package for OpenIFS. Instructions about how to do this can be found OpenIFS 48r1 GettingStarted page, section Extract the OpenIFS package.
| Note |
|---|
Download and extraction of the tarball is only required if a user has not previously done this for a general OpenIFS install. If a user has already downloaded the OpenIFS package to install the 3D model, there is no need to extract the package again, since the SCM is packaged with OpenIFS. |
Building and testing the SCM
The SCM can be built by following the instructions described OpenIFS 48r1 GettingStarted - Build OpenIFS. As described, these instructions will build, by default, both the OpenIFS executables for a 3D global simulation and the SCM executables. This step will also run a standard test to check that the SCM will run on the chosen system